Printer upgrades

Finally a bit of time to update this blog with the current state of the printer. Very little was done on the printer the last year, but during the last few weeks I had some time to do some upgrades. The printer looks like this now:

Upgrades done include:

• Ramps 1.4 electronics
• Sprinter & Slic3r software
• Heated print bed
• Stays to support the top of the printer
• Y-axis extension

I will try to write something about each upgrade later, for now just a picture displaying  the quality of the prints at this moment:

The design is from thingiverse: 3Dknot.