Sunday, April 15, 2012

Stayed Z-axis

The structural part of the Z-axis in my RepStrap 3D printer is a pair of 8 mm rods which were fixed only at the base of the printer. When printing a higher speeds, both X and Y-axes are causing the Z-axis to wobble a bit. This has not been a problem so far, but especially when printing tall objects, there where some unwanted artifacts. I decided to make the Z-axis stronger in a weekend when all the shops where closed and I had to use the materials I had at hand. The top of the Z-axis was connected to the corners of the base of the printer using steel wire which was once used to hold up a curtain.



I printed 2 plastic pieces  with an 8 mm hole in the bottom to fit at the top of the vertical rods. I used 123d to design the part.





The steel cable was fastened using the metal pieces I removed from a terminal block like this:



The pieces from the terminal block where used both a the top of the printer and below the base of the printer.





Adjusting the tension of the wires is not very easy in this setup, it requires 4 hands. But once set up, I expect this to last for a long time. This printer is stronger now and the printing quality improved again a bit.

Tuesday, April 10, 2012

Printer upgrades

Finally a bit of time to update this blog with the current state of the printer. Very little was done on the printer the last year, but during the last few weeks I had some time to do some upgrades. The printer looks like this now:




Upgrades done include:
I will try to write something about each upgrade later, for now just a picture displaying  the quality of the prints at this moment:




The design is from thingiverse: 3Dknot.